OmniPCX Enterprise
APPENDIX 2
REMARKS & RESTRICTIONS
INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
TC1449 22 Ed. 02 / 22 June 2011
These new modules are marked "Add-on UA/IP" on the packaging and on the label pasted under
the module.
10.3. Alcatel series 8 & 9 sets
− The Alcatel series 8 & 9 sets cannot be used as attendant sets.
These restrictions will be removed in next versions. As of Release 9.1, 4068 set (Fast Ethernet or
Extended Edition) can be used as attendant.
− Alcatel series 8 & 9 sets can be used as CCD sets from Release 7.0.
− Alcatel series 9 sets used as CCD sets require eUA32 boards (3BA 23266).
− The IP configuration on IP Touch series 8 sets can be locked by a password (common for the
installation).
− The series 9 sets cannot access to XML applications.
− Only the 4028-4038-4068 sets can access to XML applications.
− The 4018-4028 set cannot access to OmniTouch UC R4.0 (My Phone, My Messaging, My
Assistant).
− No total substitution but only partial.
− No hands-free on 4019 set.
− 4018 & 4019 sets do not support Electronic Add-on modules.
− 4018 & 4019 sets cannot use the call by name feature.
− Add-on modules AP (3GV 27014) and S0 (3GV 27016) are compatible with UA Reflexe and 9
series sets.
− Add-on module External ringing interface (3GV28050AA) is compatible with UA Reflexe and 8 &
9 series sets.
− Add-on module V24 / CTI (3GV 27015) is compatible with UA Reflexe sets and cannot be
declared behind 9 series sets.
− No series 9 set behind a RT2 or LIO board.
− No series 9 set in remote UA (LUTA-RUTA).
− The recording of calls on TDM sets as well as the access to the external ringing are possible with
the series 9 sets only with the following board references:
• REC8 : 3BD 19218 AHAA
• REC1 box : 3BD 19160 AEAA
• External Bell : 3BD 11086 ACAA
These boards remain compatible with the UA sets of Reflexe range.
Refer to the technical communication TC0715 REC8 board, REC1 box and external bell with
binary 3.6 < uanv ≤ 4.4 do not work.
− The Survivability feature is only supported by the IP Touch series 8 sets. The eReflexes sets are not
compatible.
To Next Page
Loading...
Need help?
General
