OmniPCX Enterprise
INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
TC1449 24 Ed. 02 / 22 June 2011
• R9.0 : H1.301.24
• R8.0.1 : G1.503.9
− The H323 Inter-node protocol parameter must be set to Yes.
− The Direct RTP (in network) parameter must be set to Yes.
− The T38 only parameter has to be managed in coherency amongst the sub-network. This
parameter for the protocol to be used when sending faxes between Media Gateways is supported
in all patches of Releases 9.0 and 9.1 and in 8.0.1 only from patch G1.503.35. NGP boards
support only the T38 fax mode between Media Gateways.
6.3 Audit/Broadcast
− Audit
All the tables not implemented in a Release generate the message below in the results of the
audit for these tables:
Not Audited: Not implemented in the version but does not cause a
blockage of the audit.
− Broadcast
On receipt of an unknown object in a Release, an error is signaled and an incident is generated.
Note
Although the audit and the broadcasting must be inhibited during the period of cohabitation, for
information purposes, these errors can be deleted by the versions below or higher:
• E2.404.b
• E2.502.2.e
• E2.504.1.e
The following tables are not broadcast:
• inst/desc/SIO parameters
• data/data prefix
• inst/desc/free numbers range list
6.4 Compatibility of external applications
In a heterogeneous network, it is essential to align the application versions with
those of Release 10.0.
See paragraph
7.9 for the versions of applications compatible with Release 10.0.
Certain applications are no more supported by Release 10.0; see paragraph
5.1.
7. COMPATIBILITIES
7.1 Reminder on boards supporting the Transit function and the direct RTP
The Transit function allows a reduction in the time introduced by a compression and decompression.
This function is only available with the G723 and G729 algorithms.
To Next Page
Loading...
Need help?
General
