OmniPCX Enterprise
INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
Ed. 02 / 22 June 2011 39 TC1449
Applications Minimum version (Note 1) Released version
TAPI Premium Server R3 3.2.2 3.3.4
TSAPI Premium Server 6.3.0 / 6.3.1 (Note 4) 6.4.7
XML Web Services Same as OTUC / OT 8400 ICS
Wizard for common hardware / crystal
hardware
No more supported
Datcol No more supported as of Release 5.1 (see § 5)
Notes
1 Allows operation with Release 10.0 but in the event of problem, the update in the released version
will be required before any investigation.
2 CS-2 (resp. GD3, GA3, INTIP3) boards are taken into account by PC Installer from version 2.24.
3 The IMAP function is available from A4635 version 5.2.6.
The VPU function is available from A4635 version 5.1.4.
4 For XL configurations, the minimum version is 6.3.1.
7.10 OEM/External equipment compatibility
7.10.1 UPS
In the case of a local 110 Volt power supply, the following MGE UPSs are compatible with the
Appliance Server concerning power cuts and battery management:
− Pulsar Evolution (Serial)
− Pulsar ESV+
− Pulsar EX
− Pulsar ES+
− Pulsar EXtreme C
− Pulsar / Comet EXtreme
− Comet / Galaxy (Serial)
The UPSs referenced in the catalog are not compatible for countries using 110/127V.
7.10.2 V24 over IP ("Moxa" unit)
On the CPU of the Call Server, a single V24 port is available and reserved for the local console. If
an application needs a V24 connection with the Call Server (AHL over V24, real time alarms, etc.),
then the "Moxa Nport Server Lite" unit must be used.
This item allows V24 calls over IP with the Call Server. Four DB9 connectors are available on the
unit. See the System documentation for management of this equipment.
7.10.3 T38 Fax over IP
T38 Fax over IP operation is supported with the MP-102 equipment version 4.0 for Fax
transmissions only.
See the technical communication TC0336 Setting the T38 fax over IP application (with MP-102
version 4.0).
To Next Page
Loading...
Need help?
General
