OmniPCX Enterprise
INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
TC1449 22 Ed. 02 / 22 June 2011
Network interworking
Each node of a network must be in Release 8.0 or higher if one of conditions below
exist on one of node of the network:
• A R8.0 node or higher in XL mode
• 50 000 users and more in network
• 1000 entities and more on a node of network
• 200 DDI translator ranges and more on one node of network
• 50 NPD and more on one node of network
• 30 DCT and more on one node of network
As the T38 fax mode between Media Gateways is implemented only in Releases
8.0.1 (since patch G1.503.35), 9.0, 9.1 and 10.0, no faxes exchange will be possible
via IP between a Release 10.0 node with NGP boards and nodes in Release prior to
8.0.1 during the temporary progressive migration phase.
Networked interworking rules for a system in Release 10.0 of which the number of
equipment does not exceed 27000 (identified with 2 bytes), have evolve compared to a
system in Release 7.1 as described hereafter.
As of Release 7.0 and with the implementation of name using UTF-8 format, the networked
interworking rules have evolved.
It is authorized to operate a Release 10.0 in a single sub-network only with systems having at least
the versions below:
• R9.1 : I1.605.12
• R9.0 : H1.301.24
• R8.0.1 : G1.503.9
• R8.0 : G1.302.5
• R7.1 : F5.401.7
• R7.0 : F4.401.13
• R6.2 : F3.301.16.e (patch for compatibility UTF-8)
• R6.1.1 : F2.502.12.d (patch for compatibility UTF-8)
• R6.0.1 : F1.603.1.z (patch for compatibility UTF-8)
Cohabitation in a single sub-network of a Release 10.0 with Releases 5.1.x, 6.x, 7.x is only
authorized temporarily to allow progressive migration to the latest supported release (in case of
5.1.x and 6.0, UTF-8 must not be activated in the network).
Cohabitation in a single sub-network of a Release 10.0 with Releases < 5.0 Ux, 5.0 Ux, 5.0 Lx is not
authorized.
During progressive migration and depending on certain topologies and hardware
used, there may be poor audio quality; see chapter
7 .
If using a CCS multi-site, each node must be in Release 10.0.
To Next Page
Loading...
Need help?
General
