OmniSwitch AOS Release 7 Network Configuration Guide March 2011 page 113
IP Specifications
Note that the maximum limit values provided in the following Specifications table are subject to available
system resources:
IP Defaults
The following table lists the defaults for IP configuration through the ip command.
Platforms Supported OS10K
RFCs Supported 791–Internet Protocol
792–Internet Control Message Protocol
826–An Ethernet Address Resolution Protocol
2784–Generic Routing Encapsulation (GRE)
2890–Key and Sequence Number Extensions to GRE
(extensions defined are not supported)
1701–Generic Routing Encapsulation (GRE)
1702–Generic Routing Encapsulation over IPV4 Net-
works
2003-IP Encapsulation within IP
Maximum router interfaces per system 4094 IP
Maximum router interfaces per VLAN 16
Maximum HW routes per switch 256K
Maximum SW routes per switch N/A
Maximum static routes per switch 4K
Maximum ARP entries per module 16K
Maximum ARP entries per system 64K
Maximum number of GRE tunnel interfaces
per switch
511
Maximum number of IPIP tunnel interfaces
per switch
511
Routing protocols supported over the tunnel
interfaces
RIP, OSPF, BGP
Maximum number of ECMP entries 512
Maximum next hops per ECMP entry 16
Description Command Default
IP-Directed Broadcasts ip directed-broadcast off
Time-to-Live Value ip default-ttl 64 (hops)
IP interfaces ip interface VLAN 1 interface.
ARP filters arp filter 0
To Next Page
Loading...
