Alcatel-Lucent OmniSwitch AOS Release 7 - Quick Steps for Configuring Switch Logging

Quick Steps for Configuring Switch Logging Using Switch Logging
page 28-4 OmniSwitch AOS Release 7 Network Configuration Guide March 2011
Quick Steps for Configuring Switch Logging
1 Enable switch logging by using the following command:
-> swlog
2 Specify the ID of the application to be logged along with the logging severity level.
-> swlog appid bridge level warning
Here, the application ID specifies bridging and the severity is set to the “warning” level.
3 Specify the output device to which the switch logging information must be sent.
-> swlog output console
-> show swlog
-> show swlog
Operational Status : Running,
File Size per file : 100K bytes,
Log Device : console flash,
Syslog FacilityID : local0(16),
Remote command-log : Disabled,
Hash Table entries age limit : 60 seconds,
Switch Log Preamble : Enabled,
Switch Log Debug : Disabled,
Switch Log Duplicate Detection : Enabled,
Console Display Level : debug3,