OmniSwitch AOS Release 7 Network Configuration Guide March 2011 page 21-29
Use the following “Policy Action Combinations Table” together with the “Supported Policy Actions
Table” as a guide when creating policy actions.
For specific information about how to configure policy conditions and actions to create a policy rule, see
“Creating Policies” on page 21-39.
Condition and Action Combinations
Conditions and actions are combined in policy rules. The CLI prevents you from configuring invalid
condition/action combinations that are never allowed; however, the following table provides a quick refer-
ence for determining which condition/action combinations are not valid. Each row represents a policy
condition or conditions combined with the policy action or actions in the same row.
Policy Action Combinations Table
Drop Priority
Stamp/
Map Max BW
Redirect
Port
Redirect
Linkagg
Port
Disable
Permanent
Gateway IP Mirror
Drop
N/ANoNoNoNoNoNoNo Yes
Priority
No N/A Yes Yes Yes Yes No Yes Yes
Stamp/Map
No Yes N/A Yes Ye s Ye s No Yes Yes
Max BW
No Yes Yes N/A Yes Yes No Yes Yes
Redirect
Port
No Yes Yes Yes N /A No No Yes Yes
Redirect
Linkagg
No Yes Yes Yes N o N /A No Yes Ye s
Port Disable
No No No No No No N/A No No
Permanent
Gateway IP
No Yes Yes Yes Ye s Yes No N/A Yes
Mirroring
Yes Yes Ye s Yes Yes Yes No Yes N/A
Policy Condition/Action Combinations
Conditions Actions Supported When?
multicast IP address or network group all actions never, except with disposition action
multicast IPv6 address all actions never, except with disposition and
mirror actions
destination VLAN all actions never, except with disposition action
in a multicast rule (a rule that uses
the “multicast” keyword and only
applies to IGMP traffic)
destination slot/port or port group all actions bridging only
To Next Page
Loading...
