Displaying IPMS Configurations and Statistics Configuring IP Multicast Switching
page 20-40 OmniSwitch AOS Release 7 Network Configuration Guide March 2011
Displaying IPMS Configurations and Statistics
Alcatel-Lucent’s IP Multicast Switching (IPMS) show commands provide tools to monitor IPMS traffic
and settings and to troubleshoot problems. These commands are described below:
If you are interested in a quick look at IPMS groups on your switch you could use the
show ip multicast group command. For example:
-> show ip multicast group
Total 3 Groups
Group Address Source Address VLAN Port Mode Static Count Life
---------------+---------------+-----+-----+--------+-------+------+-----
231.0.0.3 1.0.0.5 1 2/1 exclude no 1 257
234.0.0.4 0.0.0.0 1 2/1 exclude no 1 218
229.0.0.1 0.0.0.0 1 2/13 exclude yes 0 0
Note. See the “IP Multicast Switching Commands” chapter in the OmniSwitch CLI Reference Guide for
complete documentation on IPMS show commands.
show ip multicast Displays the general IP Multicast switching and routing configuration
parameters on a switch.
show ip multicast group Displays all detected multicast groups that have members. If you do not
specify an IP address then all multicast groups on the switch is
displayed.
show ip multicast neighbor Displays all neighboring multicast routers.
show ip multicast querier Displays all multicast queriers.
show ip multicast port Displays the IPMS multicast forwarding table. If you do not specify a
multicast group IP address, then the forwarding table for all multicast
groups are displayed.
show ip multicast source Displays the IPMS multicast source table. If you do not specify a
multicast group IP address, then the source table for all multicast groups
are displayed.
show ip multicast tunnel Displays the IP multicast switch and routing tunneling table entries
matching the specified IP multicast group address, or all the entries if no
IP multicast address is specified.
To Next Page
Loading...
