sFlow Diagnosing Switch Problems
page 26-32 OmniSwitch AOS Release 7 Network Configuration Guide March 2011
Displaying a sFlow Agent
The show sflow agent command is used to display the receiver table.
For example, to view the sFlow agent table, enter the show sflow agent command without specifying any
additional parameters. A screen similar to the following example is displayed, as shown below:
-> ip interface Loopback0 127.0.0.1
-> show sflow agent
Agent Version = 1.3; Alcatel-Lucent; 6.1.1
Agent IP = 127.0.0.1
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
Deleting a sFlow Session
To delete a sFlow receiver session, use the release form at the end of the sflow agent command by enter-
ing sflow receiver, followed by the receiver index and release. For example, to delete sFlow receiver
session 6, enter:
-> sflow receiver 6 release
To delete a sFlow sampler session, use the no form of the sflow sampler command by entering no sflow
sampler, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the port
number of the port, enter:
-> no sflow sampler 1 port 2/3
To delete a sFlow poller session, use the no form of the sflow poller command by entering no sflow
poller, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the port
number of the port, enter:
-> no sflow poller 3 port 1/1
To Next Page
Loading...
