page 152 OmniSwitch AOS Release 7 Network Configuration Guide March 2011
RIP Specifications
RIP Defaults
The following table lists the defaults for RIP configuration through the ip rip command.
Platforms Supported OS10K
RFCs Supported RFC 1058–RIP v1
RFC 2453–RIP v2
RFC 1722–RIP v2 Protocol Applicability Statement
RFC 1724–RIP v2 MIB Extension
Maximum Number of Interfaces 10
Maximum Number of Peers 100
Maximum Number of Routes 10K
Maximum Number of ECMP Entries 512
Maximum Number of ECMP Next Hops 16
Description Command Default
RIP Status ip rip admin-state disable
RIP Forced Hold-Down Interval ip rip force-holddowntimer 0
RIP Update Interval ip rip update-interval 30 seconds
RIP Invalid Timer ip rip invalid-timer 180 seconds
RIP Garbage Timer ip rip garbage-timer 120 seconds
RIP Hold-Down Timer ip rip holddown-timer 0
RIP Interface Metric ip rip interface metric 1
RIP Interface Send Version ip rip interface send-version v2
RIP Interface Receive Version ip rip interface recv-version both
RIP Host Route ip rip host-route enable
RIP Route Tag ip rip host-route 0
To Next Page
Loading...
