Alcatel-Lucent OmniSwitch AOS Release 7 - Verifying the RIP Configuration

OmniSwitch AOS Release 7 Network Configuration Guide March 2011 page 1519
Verifying the RIP Configuration
A summary of the show commands used for verifying the RIP configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show ip rip Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
show ip rip routes Displays the RIP routing database. The routing database contains all
the routes learned through RIP.
show ip rip interface Displays the RIP interface status and configuration.
show ip rip peer Displays active RIP neighbors (peers).
show ip redist Displays the currently configured RIP redistribution filters.