Alcatel-Lucent OmniSwitch AOS Release 7 - Disabling an Ip Address from Receiving Switch Logging Output

Switch Logging Commands Overview Using Switch Logging
page 28-10 OmniSwitch AOS Release 7 Network Configuration Guide March 2011
Disabling an IP Address from Receiving Switch Logging Output
To disable all configured output IP addresses from receiving switch logging output, enter the following
command:
-> no swlog output socket
No confirmation message appears on the screen.
To disable a specific configured output IP address from receiving switch logging output, use the same
command as above but specify an IPv4 or IPv6 address. For example:
-> no swlog output socket 174.16.5.1