page 21-76 OmniSwitch AOS Release 7 Network Configuration Guide March 2011
In this scenario, traffic from the firewall is sent back to the switch to be re-routed. But because the traffic
re-enters the switch through a port that is not in the Slot01 port group, the traffic does not match the
Redirect_All policy and is routed normally through the switch.
-> policy condition Traffic3 source ip 10.3.0.0 mask 255.255.0.0 source port
group Slot01
-> policy action Firewall permanent gateway ip 173.5.1.254
-> policy rule Redirect_All condition Traffic3 action Firewall
Make sure to enter the qos apply command to activate the policy rule on the switch. Otherwise the rule is
saved as part of the pending configuration, but is not active.
To Next Page
Loading...
