Publication 1394-5.0 — May 2000
1-2 Overview
Safety Precautions
The following general precautions apply to the 1394:
!
ATTENTION: Only those familiar with the 1394
Digital, AC, Multi-Axis Motion Control System and
associated machinery should plan or implement the
installation, startup, and subsequent maintenance of
the system. Failure to comply can result in personal
injury and/or equipment damage.
ATTENTION: This product contains stored energy
devices. To avoid hazard of electrical shock, wait five
minutes after removing power or verify that all voltage
on the capacitors has been discharged before
attempting to service, repair, or remove this unit. You
should only attempt the procedures in this manual if
you are qualified to do so and familiar with solid-state
control equipment and the safety procedures in
publication NFPA 70E.
ATTENTION: The system integrator is responsible
for local safety and electrical codes.
!
ATTENTION: An incorrectly applied or installed
drive can result in component damage or a reduction
in product life. Wiring or application errors, such as
undersizing the motor, incorrect or inadequate AC
supply, or excessive ambient temperatures can result
in malfunction of the drive.
ATTENTION: This drive contains ESD
(Electrostatic Discharge) sensitive parts and
assemblies. Static control precautions are required
when installing, testing, servicing, or repairing this
assembly. Component damage can result if ESD
control procedures are not followed. If you are not
familiar with static control procedures, refer to Allen-
Bradley publication 8000-4.5.2, Guarding Against
Electrostatic Damage or any other applicable ESD
Protection Handbook.
To Next Page
Loading...
Need help?
General
