Allen-Bradley 1394 - Pasting a Systems Information; Publication 1394-5.0 - May

Publication 1394-5.0 — May 2000
Using the Human Interface Module (HIM) C-9
10. Repeat steps 8. through 10. until the complete name you want
appears.
11. Press ENTER. The cursor moves to the location number.
12. Press ENTER. A message similar to the following appears:
Note: The version number on the bottom of the display represent
the firmware revision of the information that you will copy.
13. Press ENTER. The copy begins and a message similar to the
following appears:
Note: The numbers of the parameters scroll as they are copied and
more solid boxes appear on the bottom to show the status
of the copy.
When the copy is complete, a message similar to the following
appears:
14. Press ESC. A message similar to the following appears:
Pasting a System’s Information
To place one system’s information into another system using Copy
Cat:
1. Connect the HIM to the system into which you want to paste the
information stored in the HIM.
2. At the HIM, press ENTER. A message similar to the following
appears:
3. Press either the up or down arrow key until the following appears:
4. Press ENTER. The system records your choice and the following
message appears:
5. Press either the up or down arrow key until the following appears:
B1394 Servo Drv
V
ersion 3.00
Drive -> HIM ##
■
Drive --> HIM ###
Completed
Choose Mode
EEPROM
Choose Mode
Display
Choose Mode
EEPROM
EEPROM
Save Values
EEPROM
HIM -> Drive