Allen-Bradley 1394 - User-Supplied Contactor (M1; User-Supplied Line Input Fusing

Publication 1394-5.0 — May 2000
Specifications A-5
User-Supplied Contactor (M1)
The table below shows the requirements for the contactor that you
must supply.
User-Supplied Line Input Fusing
The table below shows the requirements for the input fusing that you
must supply.
User-Supplied 24V Logic Input Power
The table below shows the requirements for the 24V logic input
power that you must supply.
The contactor: For the 1394-SJT05 and
-SJT10 (Series A and B) is:
For the 1394C-SJT05 and
-SJT10 (Series C) is:
For the 1394 x -SJT22 is:
Rating 600V AC, 43A
1
600V AC, 23A 600V AC, 37A
Recommended
types:
AC Coil Operation Allen-Bradley 100-C43
x 10
2,3
Allen-Bradley 100-C23 x 10
2,3
Allen-Bradley 100-C37 x 10
2,3
DC Coil Operation Allen-Bradley 100-C43Z
x 10
2
Allen-Bradley 100-C23Z x 10
2
Allen-Bradley 100-C37Z x 10
2
1
Consider using a 60A contactor when the total capacitance of the axis modules is greater than 880 µF.
2
x indicates coil voltage.
3
A surge suppressor is required.
The Recommended type of fuse for: Is: Rating
1394-SJT05 systems Series A and B Bussmann FRS-R-20A or
equivalent
600V AC, 20A
1394C-SJT05 systems Series C Bussmann KTK-R-20 or
equivalent
600V AC, 20A
Bussmann LPJ-SP 20 or
equivalent
600V AC, 20A
1394-SJT10 systems Series A and B Bussmann FRS-R-30A or
equivalent
600V AC, 30A
1394C-SJT10 systems Series C Bussmann KTK-R-30 or
equivalent
600V AC, 30A
Bussmann LPJ-SP 30 or
equivalent
600V AC, 30A
1394
x -SJT22 systems Bussmann FRS-R-35 or
equivalent
600V AC, 35A
Bussmann LPS-RK-SP 40
or equivalent
600V AC, 40A
Bussmann LPJ-SP 45 or
equivalent
600V AC, 45A
24V logic input
voltage
Frequency Current
1
Recommended Fuse
If you have: The current draw for user-
supplied power supply
must not exceed:
19-28V AC RMS,
single phase or
50/60 Hz
1 axis 3.5A
Bussmann MDA-15
or equivalent
2 axis 4.4A
18.75-31.25V DC 3 axis 5.2A
4 axis 6.0A
1
The power supply should be rated for 15A or greater inrush current upon power up.