38 Rockwell Automation Publication IASIMP-QS035B-EN-P - April 2015
Chapter 1 Add a Kinetix 5500 Drive to a Logix Designer Application
15. Click the Power tab.
16. From the pull-down menus, choose the power options appropriate for your actual hardware configuration.
17. Click OK.
18. Repeat
step 1 through step 17 for each 2198-Hxxx-ERS servo drive.
Attribute Menu Description
Voltage • 400-480 VAC
• 200-240 VAC
AC input voltage class.
AC Input Phasing •Three Phase
• Single Phase
AC input phase. Kinetix 5500 drives with single-
pha
se operation are limited to 2198-H003-ERS,
2198-H008-ERS, and 2198-H015-ERS.
Bus Configuration
(1)
(1) See the Kinetix Servo Drives User Manual, publication 2198-UM001, for more information on bus configuration and bus
sharing. For this quick start, configure these fields as Standalone.
Standalone Applies to single-axis drives and drives with
Shared AC input configurations.
Shared AC/DC Applies to converter drives with Shared AC/DC and
Shared AC/DC Hybrid input configurations.
Shared DC Applies to inverter drives with Shared DC input
(common-bus) configurations.
Bus Sharing Group
(1)
Standalone Applies to standalone bus configurations.
•Group1
•Group2
•Group3…
Applies to any bus sharing configuration.
Shunt Regulator Action Disabled Disables the internal shunt resistor and external
shunt option.
Shunt Regulator Enables the internal and ex
ternal shunt options.
Shunt Regulator Resistor Type Internal Enables the internal shunt (external shunt option
is disabled).
External Enables the external shunt (internal shunt option
is disabled).
External Shunt
(2)
(2) See the Kinetix Servo Drives Specifications Technical Data, publication GMC-TD003, for more information on the Bulletin
2097 external shunt resistors.
•None
• 2097-R6
• 2097-R7
Selects external shunt option. Only the shunt
model that is intended for the drive model is
shown.
To Next Page
Loading...
Need help?
General
