High-Speed Counter (HSC) instructions Chapter 14
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015 347
Result
The Variables page should look similar to the following image.
Assign values to the HSC variables
After you add variables, follow these steps to add values to the variables using the
Initial Value column in the Variable Selector. A standard program usually uses a
routine to assign values to the variables.
To assign values to the HSC variables
1. Expand MyAppData to view all variables.
2. Assign the HSC mode value:
• In the Initial Value field for the MyAppData.HSCMode variable, type
6.
• See HSCMode in HSCAPP data type on page 314 for more
information on the description for each value.
To Next Page
Loading...
