Alliance Laundry Systems CCN020KNF - Control Identification; Select Cycle Keypads

Control Identification
Select Cycle Keypads
(Refer to Figure 1 )
Select Cycle keypads are used to select the specific machine cy-
cle. These pads are numbered 0-9 and allow the user to select a
cycle other than the default cycle (#5). The Select Cycle keypads
are not active after starting a cycle. Pressing the flashing START
(enter) keypad will confirm the selection and the cycle will begin.
The Select Cycle keypads are used in various combinations for
programming cycles, retrieving audit information, running diag-
nostic tests, and other operations. These instructions cover the
manual programming and data retrieval options.
CHM537R_SVG1
2
31
4
5
6
7
1. Select Cycle keypads
2. Display
3. Four 7-Segment Digits
4. STOP UNLOCK keypad (125 lb. models) or STOP keypad (all other models)
5. START (enter) keypad
6. LED Light
7. LED Status Lights
Figure 1
Control Identification
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
10 Part No. F8238101ENR11