Default Cycle dCYC
This option allows the owner to set the default cycle the machine
will enter when in the Start Mode.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2.
Press the #3 (∧) or the #6 (∨) keypad until Prog appears in
the display. Press the START (enter) keypad and dCYC will
appear in the display.
3. Press the #3 (∧) or the #6 (∨) keypad to increase or decrease
the current number to the desired number.
4. Press the START (enter) keypad when the correct number ap-
pears in the display. The next option, AUd , will appear in the
display.
NOTE: To program AUd (Audio Signal), refer to Audio
Signal AUd. To program other options, refer to the
appropriate section.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
27 Part No. F8238101ENR11
To Next Page
Loading...
