Entering the Manual Mode
For programming, testing, and retrieving information from the
control, it is often necessary to enter the Manual Mode by follow-
ing the six (6) simple steps below.
For an overview the Manual Mode, refer to Entering Manual
Mode.
How to Enter the Manual Mode
1. Open the top cover. Refer to Opening the Top Cover.
2. While pressing and holding the #4 keypad with one hand,
press the #1 keypad with the other hand.
3.
The display will show rAPd.
4. Press the #3 (∧) or the #6 (∨) keypad to scroll through the op-
tions until the desired option appears in the display.
5. Press the START (enter) keypad.
Manual Mode is broken into three (3) groups: Manual Program-
ming, Manual Rapid Advance and Manual Diagnostics. Manual
Programming can only be turned on or off with an external de-
vice. Refer to the appropriate instruction manual. Manual Rapid
Advance and Manual Diagnostics can be turned on and off using
an external device or by manual programming (refer to Manual
Rapid Advance (Enable/Disable) rAEn and Manual Diagnostics
(Enable/Disable) dAEn of Programming Control).
By default, all groups are turned on.
The manual features available in each group are as follows (the
menu displayed on the display in this mode is in parentheses).
• Manual Programming
•
Manual Programming (Prog)
•
Manual Read Audit (AUdt)
•
Manual Reset (rSEt)
• Manual Rapid Advance
•
Rapid Advance (rAPd)
• Manual Diagnostics
•
Manual Diagnostic Tests (diAg)
If a group is turned off, the display will change from the selected
feature to oFF when the START (enter) keypad is pressed and an
audio signal will sound for one (1) second. The display will then
return to the selected feature. The features in the group cannot be
entered.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to Ready Mode.
Entering the Manual Mode
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
15 Part No. F8238101ENR11
To Next Page
Loading...
