Alliance Laundry Systems CCN020KNF - Production Test Cycle (Enable;Disable) Pten; Manual Rapid Advance (Enable;Disable) Raen

Production Test Cycle (Enable/Disable)
PtEn
This option allows the owner to enable or disable access to the
production test cycle. Refer to Production Test Cycle section for
more information.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2.
Press the #3 (∧) or the #6 (∨) keypad until Prog appears in
the display. Press the START (enter) keypad and dCYC will
appear in the display.
3. Press the #3 (∧) or the #6 (∨) keypad to scroll through the pro-
grammable options until PtEn appears in the display.
4.
When PtEn appears in the display, press the START (enter)
keypad. The current Production Test Cycle status will appear
in the display.
on = Option Enabled (default setting)
oFF = Option Disabled
5. Press the #3 (∧) or the #6 (∨) keypad to change the current
status.
6. Press the START (enter) keypad when the desired status ap-
pears in the display. The next option, rAEn, will appear in the
display.
NOTE: To program rAEn (Manual Rapid Advance
[Enable/ Disable]), refer to Manual Rapid Advance (En-
able/Disable) rAEn. To program other options, refer to
the appropriate section.
Manual Rapid Advance (Enable/
Disable) rAEn
This option allows the owner to enable or disable the rapid ad-
vance feature. Refer to Rapid Advance Feature section for more
information.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2.
Press the #3 (∧) or the #6 (∨) keypad until Prog appears in
the display. Press the START (enter) keypad and dCYC will
appear in the display.
3. Press the #3 (∧) or the #6 (∨) keypad to scroll through the pro-
grammable options until rAEn appears in the display.
4.
When rAEn appears in the display, press the START (enter)
keypad. The current Manual Rapid Advance status will ap-
pear in the display.
on = Option Enabled (default setting)
oFF = Option Disabled
5. Press the #3 (∧) or the #6 (∨) keypad to change the current
status.
6. Press the START (enter) keypad when the desired status ap-
pears in the display. The next option, nCtd, will appear in the
display.
NOTE: To program nCtd (No Cycle Time Display),
refer to No Cycle Time Display nCtd. To program other
options, refer to the appropriate section.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
45 Part No. F8238101ENR11