Preliminary Information
About the Control
This control is an advanced, programmable computer that allows
the owner to control most machine features by pressing a se-
quence of keypads.
The control allows the owner to program custom cycles, set vend
prices, retrieve audit information, run diagnostic tests, program
special vend features and other programmable features. Refer to
Programming the Control for a list of features. Machines shipped
from the factory have a default cycle built in, however, the owner
can change the default cycle, or any cycle, as needs permit.
The default cycle is #5.
IMPORTANT: In the event of a power failure, the control
will not have to be reprogrammed. It is designed with a
memory system that will remember how it was pro-
grammed until the electrical power is restored.
IMPORTANT: It is extremely important that the machine
has a good ground connection and that all mechanical
and electrical connections to the control are made be-
fore applying power to or operating the machine.
Glossary of Terms
The following are a few terms and abbreviations to learn. These
are referred to throughout the instructions.
Display – This term refers to the window area of the control that
displays words and values.
LED (Light Emitting Diode) – This term refers to the lights next
to the keypads and status words of the control.
Power Failure Recovery
If a cycle is in progress and the power fails for less than five (5)
seconds, the cycle status is saved in memory. When the power re-
covers, the machine will resume into the previously active cycle.
If the length of the power failure is greater than five seconds, the
control will end the cycle and the display will revert back to Start
Mode.
Communications
The control may be programmed manually or by infra-red com-
munication with an external device.
An external device, such as a PDA, allows the owner to program
and retrieve information from the control without touching the
keypad. An external device greatly expands the programming op-
tions available to the owner. However, it is not required to pro-
gram and operate the machine. The operation of an external de-
vice and the advanced features available are covered separately in
the instructions included with the external device software. Con-
tact Alliance Laundry Systems for a list of approved PDAs and
other external devices.
Preliminary Information
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
9 Part No. F8238101ENR11
To Next Page
Loading...
