Opening the Top Cover
To manually program the control, the top cover must be opened.
Opening and closing the top cover trips a switch which allows ac-
cess to various programming options. Once opened, the top cover
may either be left open, and then closed after programming, or it
may be closed immediately.
The top cover is located on the top of the machine.
1. Unlock top cover.
2. Slide top cover forward slightly to move notches away from
the pegs on the front of cabinet.
3. Lift the top cover up. To completely remove, lift top cover
away from both top cover hinges. Refer to Figure 2 .
After removing, or opening and closing the top cover, the opera-
tor has 4 minutes and 15 seconds to begin programming. If the
appropriate keypads have not been pressed in that time, the con-
trol will not accept operator programming. Should this happen,
opening and closing the top cover will once again trip the switch
which allows access to the programming options.
1. Top Cover Lock
2. Top Cover
3. Top Cover Hinge
4. Peg
Figure 2
Opening the Top Cover
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
14 Part No. F8238101ENR11
To Next Page
Loading...
