Programming Control
What Can Be Programmed?
This section offers a detailed description of all available program-
mable options.
Each description includes instructions on when and why the op-
tion might be used and, more importantly, how to program the
option.
For an overview of the programming organization, refer to the
flowcharts on the following pages.
For more advanced users, see the quick reference list (refer to Ta-
ble 1) and programming flowcharts (refer to Programming Flow-
charts) for the options available through the programming mode.
NOTE: The codes in the Option Display column of Table
1 are displayed when that option is selected.
Programmable Options Available
Option
Number
Option Dis-
play Description Default Value Value Range
1
dCYC
Default Cycle Cy05* Cy01-Cy30*
2
AUd
Audio Signal 29* 0-31*
3
Err-
Errors — —
a.
E FL
Fill Errors
on on/oFF
b.
E dr
Drain Error
on on/oFF
c.
E Ub
Unbalance Error Display
on on/oFF
d.
E oP
Open Thermister Error Dis-
play
on on/oFF
e.
E SH
Shorted Thermistor Error Dis-
play
on on/oFF
f.
E Ht
Heat Error Display (Heater
only)
on on/oFF
g.
LEr
Water Leak Detection Error — —
1.
LEr1
Water Leak Detection During
a Machine Cycle (On/Off)
oFF on/oFF
2.
LEr2
Water Leak Detection Day of
Week Enable
127* 0-127*
3.
LEr3
Number of cycles between
leak detection test
0* 0-127*
h.
E Sd
Slow Drain Detection
oFF on/oFF
4
Cy--
Cycle Programming Refer to Default Cycles for
default cycle information
a.
AgIt
Cycle Agitate — —
1.
tyPE
Agitate Type ** 1-4*
2.
ASPd
Agitate Speed (VFD only) **
Lo/rEg*
Table 1 continues...
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
16 Part No. F8238101ENR11
To Next Page
Loading...
