Fahrenheit/Celsius t FC
This option allows the owner to set whether the display will be
shown in Fahrenheit or Celsius.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2.
Press the #3 (∧) or the #6 (∨) keypad until Prog appears in
the display. Press the START (enter) keypad and dCYC will
appear in the display.
3. Press the #3 (∧) or the #6 (∨) keypad to scroll through the pro-
grammable options until t FC appears in the display.
4.
When t FC appears in the display, press the START (enter)
keypad. A number will appear in the display. This number
corresponds to the current Fahrenheit/Celsius setting.
CEL = Celsius
FAHr = Fahrenheit (default setting)
5. Press the #3 (∧) or the #6 (∨) keypad to increase or decrease
the current number to the desired number.
6. Press the START (enter) keypad when the correct number of
degrees appears in the display. The new value is saved and the
next option, FH, will appear in the display.
NOTE: To program FH (Hot Water Temperature), re-
fer to Hot Water Temperature FH. To program other op-
tions, refer to the appropriate section.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
42 Part No. F8238101ENR11
To Next Page
Loading...
