Temperature Controlled Fill Enable/
Disable tCF
This option allows the owner to enable or disable a Temperature
Controlled Fill. When enabled, the control will regulate the tem-
perature of the fill to the temperature programmed in Hot Water
Temperature FH, Warm Water Temperature FHC and Cold Water
Temperature FC.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2.
Press the #3 (∧) or the #6 (∨) keypad until Prog appears in
the display. Press the START (enter) keypad and dCYC will
appear in the display.
3. Press the #3 (∧) or the #6 (∨) keypad to scroll through the pro-
grammable options until tCF appears in the display.
4.
When tCF appears in the display, press the START (enter)
keypad. The current Temperature Controlled Fill status will
appear in the display.
on = Option Enabled
oFF = Option Disabled (default setting)
5. Press the #3 (∧) or the #6 (∨) keypad to change the current
status.
6. Press the START (enter) keypad when the desired status ap-
pears in the display. The next option, ALd-, will appear in the
display.
NOTE: To program ALd- (Auto-Water Leak Detec-
tion), refer to Auto-Water Leak Detection ALd-. To pro-
gram other options, refer to the appropriate section.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
51 Part No. F8238101ENR11
To Next Page
Loading...
