CHM1372R_SVG
“dCYC” - Set the default cycle
and temperature
“Aud” - Program when the signal will sound
“Err” - Turn on/off certain errors in control
“E FL” - Fill Error
“E dr” - Drain Error
“E Ub” - Unbalance Error (VFD only)
“E oP” - Open Thermistor Error
(Models with Heat)
“E SH” - Shorted Thermistor Error
(Models with Heat)
“E Ht” - Heat Error (Heater only)
“LEr-” - Leak Detection
“E Sd” - Slow Drain Detection
“FILL” - Program Fill Step Options
“LEr1” - Water Leak Detection during a
Machine Cycle
“LEr2” - Water Leak Detection
Day of Week
“LEr3” - Number of Cycles Between
Leak Detection Test
"Cy- -" - Program aspects for the various
steps in each type of cycle. There are
(30) cycles available for programming
“tyPE” - Agitation Type:
“1” = 18/3/18
“2” = 10/20/10
“3” = 3/27/3
“4” = 4/56/4
“SEg1” - Program Options for each
Segment. There are (8) Segments
Available for Programming
“ASPd” - Agitation Speed (VFD only):
“Lo” - Reduced Speed
“rEg” - Normal Speed
“FLEn” - Fill Step Enable/Disable:
“on” = Enable
“oFF” = Disable
“FLEU” - Fill Level:
“HI” = High Level
“nEd” = Medium Level
“Lo” = Low Level
“1” - “30” = Fill Level
“tEnP” - Fill Temperature:
“CoLd” = Cold
“Uarn” = Warm
“Hot” = Hot
(35°F - 194°F [2°C - 90°C])
“SgEn” - Segment Enable/Disable
on = Enable
oFF = Disable
“AgIt” - Program the Cycles Agitation
Action and Speed
(continued)(continued)(continued)
To Next Page
Loading...
