Allied Telesis AT-8000S Series User Manual

Page 80
Allied Telesis AT-8000S Switch
Web Browser Interface User’s Guide
– Enable — Enables GVRP on the selected device.
– Disable — Disables GVRP on the selected device.
• Port — Displays the ports table.
• Trunk — Displays the trunks table.
• Interface — Displays the port or trunk on which GVRP is enabled. The possible field values are:
– Port — Indicates the port number on which GVRP is enabled.
– Trunk — Indicates the LAG number on which GVRP is enabled.
• GVRP State — Indicates if GVRP is enabled on the port. The possible field values are:
– Enable — Enables GVRP on the selected port.
– Disable — Disables GVRP on the selected port.
• Dynamic VLAN Creation — Indicates if Dynamic VLAN creation is enabled on the interface. The possible
field values are:
– Enable — Enables Dynamic VLAN creation on the interface.
– Disable — Disables Dynamic VLAN creation on the interface.
• GVRP Registration — Indicates if VLAN registration through GVRP is enabled on the device. The possible
field values are:
– Enable — Enables GVRP registration on the device.
– Disable — Disables GVRP registration on the device.
2. Select Enable GVRP.
3. Define the GVRP parameters.
4. Click Apply. The global GVRP parameters are saved and the device is updated.
5. Click Save Config on the menu to permanently save the change.
6. Select Port and Unit or Trunk.
7. Click Modify. The GVRP Port Configuration Page opens:

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing