Allied Telesis AT-8000S Series User Manual

Page 112
Allied Telesis AT-8000S Switch
Web Browser Interface User’s Guide
Enabling SNMP
The SNMP Global Page provides fields for globally enabling and configuring SNMP on the device.
To enable SNMP:
1. Click SNMP > Global. The SNMP Global Page opens:
Figure 69: SNMP Global Page
The SNMP Global Page contains the following fields:
• Enable SNMP Access — Indicates if the protocol is enabled for the device. The possible values are:
– Checked — SNMP is enabled.
– Unchecked — SNMP is disabled.
• Local Engine ID (5-32 Characters) — Displays the engine number.
• Use Defaults — Restores default SNMP settings.
• Enable SNMP Notifications — Indicates if SNMP traps are enabled for the device. The possible values are:
– Checked — Traps are enabled.
– Unchecked — Traps are disabled.
• Enable Authentication Notifications — Indicates if authentication error notifications are enabled on the
device. The possible values are:
– Checked — Notifications are enabled.
– Unchecked — Notifications are disabled.
2. Define the fields

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing