PAGE7
1 GENERAL INFORMATION.
This document contains proprietary information. All rights reserved.
This document cannot be reproduced, in whole or in part, without the prior written consent of ALMAC
s.r.l.
The use of this document is permitted only to the customer to whom the manual was provided as a kit
with the equipment, and only for purposes of use and maintenance of the equipment to which the manual
refers.
ALMAC s.r.l. declares that the information contained in this manual is consistent with the technical and
safety specifications of the equipment to which the manual refers. ALMAC s.r.l. assumes no responsibility
for direct or indirect damage to people, things or animals resulting from the use of the equipment in
conditions other than those provided.
ALMAC s.r.l. reserves the right to make changes or improvements without notice to this document and to
the equipment, without any obligation to update equipment already sent.
The information contained in this manual refers to the various equipment mentioned on the cover; some
images and / or information may not be specific to the set-up in the customer's possession because they
are not available or available on request.
1.1 Regulatory and legal aspects.
1.1.1 Documentation supplied.
The machine is delivered complete with the following documentation:
- Instruction manual (this document) including the Control Register;
- Spare parts manual;
- EC mark applied to the machine;
- EC declaration of conformity;
- Hydraulic scheme;
- Wiring diagram.
The instruction manual and the attached documents are integral parts of the machine and a copy of
these, together with the certificates of the mandatory periodic checks, must be kept on the machine in
the appropriate box. The original documents must be kept in a dry and protected place; in case of change
of ownership these documents must always accompany the machine.
In case of loss or damage, a new copy must be requested, specifying the model and serial number of the
machine.
1.1.2 Notification of commissioning, first check, subsequent periodic checks and
transfer of ownership.
The legal obligations of the owner of the machine differ according to the state in which the machine is
put into service. It is advisable to inquire about the procedures envisaged in your area at the bodies for
the protection of safety in the workplace. In order to improve the filing of documents and to record the
modification / assistance work, a section has been provided at the end of this booklet called "Control
Register".
To Next Page
Loading...
Need help?
General