PAGE132
8 MAINTENANCE.
8.1 Safety rules during maintenance.
- Always carry out maintenance operations in conditions of maximum safety, with the machine stopped
and off, having extracted the key from the control panel on the ground, with the emergency buttons
pressed and wearing the individual protection devices suitable for the operations to be performed.
- Only adequately trained personnel are authorized to carry out repairs and maintenance on the
machine.
- The maintenance operations described refer to the machine used in "normal" conditions; if you
believe that the conditions of use of the machine are extreme (extreme temperatures, corrosive
environments, very long work cycles, etc.) or if the machine has been inactive for long periods,
contact the ALMAC technical service to adjust the frequency of the interventions.
- In case of need to replace parts of the machine, use only original parts or those approved in writing
by ALMAC; the use of non-original or unapproved spare parts leads to the forfeiture of the warranty
and of any liability on the part of ALMAC.
- Changes or additions to the PLE are not permitted unless expressly authorized by ALMAC SRL.
- During maintenance or technical assistance, the machine must be completely blocked. Do not act on
the valves installed directly on the hydraulic cylinders of the arms and stabilizers if these have not
been immobilized / blocked: risk of uncontrolled movement of the structure.
- Do not insert the body, limbs, or fingers into the sharply articulated openings of parts of the machine
which are not controlled and without suitable guards, unless they are securely locked;
- Disconnect the machine from all external energy sources (110-230V single-phase power line) before
intervening.
- Before disassembling fittings or pipes, make sure there are no pressurized fluids: oil that escapes
under pressure can cause serious injuries. In case of injury or accidental ingestion of fluids that come
out of pipes etc…, consult a doctor immediately. In particular, remember that the fluid that leaks
from a very small hole can be almost invisible and have sufficient strength to penetrate under the
skin. To find any leaks, use cardboard or a piece of wood
- For maintenance operations on the heat engine, consult the manual provided by the manufacturer,
and attached it to the machine documentation at the time of delivery.
- Carry out maintenance operations when the fluids (hydraulic oil, lubricating oils) are sufficiently
cooled.
- Hydraulic oil, lubricants, electrolytes and additives to radiator coolants must be handled with care
and discharged safely in compliance with current regulations. Prolonged skin contact can cause
irritation and dermatosis. Wash with soap and water, then rinse well if you come into contact with
any of these items. Contact with eyes is also dangerous: wash abundantly with water and seek
medical attention.
- Put the machine out of service, isolate and report the situation to your employer if there is an
anomaly in a mechanical, or hydraulic element or in a control or safety device. NOTIFY AN ALMAC
S.r.l. SERVICE CENTER IMMEDIATELY
It is absolutely forbidden to modify or tamper with the machine parts and sensors. ALMAC is relieved
of any responsibility in case of modifications / tampering.
To Next Page
Loading...
Need help?
General