PAGE9
1.1.3 Training, information and training of operators.
Training, information and training of operators are legal obligations for the employer. The employer must
in fact ensure that the workers in charge of the use of the equipment receive adequate and specific
training to allow their use in a suitable and safe way, also in relation to the damage that may be caused
to other people and things. Remember that both the one who directly manoeuvres the machine and the
one on the ground for any recovery and rescue operations are considered operators.
The operators in charge must be at least 18 years old and be recognized as suitable from a psycho-physical
point of view for this task. In particular, before driving, it is necessary to check the following
requirements:
- Sight and hearing in good condition;
- Absence of alterations induced by the use of alcohol or drugs;
- Psychological balance, absence of depression or stress.
1.1.4 Tests are carried out before delivery.
Before being placed on the market, each example of the ALMAC platform was subjected to the following
tests:
▪ Braking test
▪ Overload test
▪ Function test
1.1.5 Warranty, Request for intervention under warranty and technical assistance.
1.1.5.1 Warranty and disclaimer.
ALMAC S.r.l. guarantees the devices of its own production and undertakes to replace, free of charge, in
the shortest time possible, those parts that in its opinion are found to be defective.
Any intervention under warranty can only be carried out at authorized ALMAC S.r.l. and on the condition
that the Customer is up to date with the payments.
The warranty is not recognized if the customer does not deliver the appliance for repair within 30 days
from the date of the first complaint to be made in writing.
With the exception of cases of willful misconduct or gross negligence, any liability of ALMAC S.r.l. to the
Customer is excluded. for any damage resulting from faults/defects in the devices sold.
ALMAC S.r.l. is relieved of any liability and the warranty is void in the following cases:
- Use not permitted or not intended by this manual;
- Improper use of the machine or its use by not instructed and / or untrained personnel;
- Use that does not comply with specific regulations;
- Lack of maintenance and / or not on time;
- Removal of seals;
- Modifications have been made to the machine without the prior written authorization of
ALMAC S.r.l.;
- Non-original spare parts or spare parts not approved by ALMAC s.r.l. are used.
To Next Page
Loading...
Need help?
General