According to the periodicity described in the
maintenance table, proceed with greasing the
points equipped with grease nipples and the
telescopic appendages indicated in the image
alongside.
To grease the telescopic arms, fully extend the
extensions (with the jib completely closed, and no
load on the platform) by raising the arm slightly to
avoid interference between the basket and the
ground, and use a brush to lightly grease the
surfaces of the telescopic extensions that they
come into contact with the skates. Before
greasing, remove any dirt accumulated on the
parts. After greasing, retract the telescopic
extensions and pull them out again, then remove
the excess grease.
Remember to proceed with the greasing of the
same points, always:
- After a machine wash;
- Before using the machine after long
periods of inactivity;
- Malicious use of the machine in hostile
environments (very humid, very dusty,
coastal areas, etc.).
Warning: Use only lubricating grease with the same
characteristics as those shown in the table below.
To Next Page
Loading...
Need help?
General