PAGE105
5.1.4.4 Winch control (optional).
Except for the JIBBI U-1570 model, on the other JIBBI 12xx and JIBBI16xx models, it is possible to install,
as INTERCHANGEABLE EQUIPMENT, a winch in place of the platform, allowing the machine to be used as
a crane for loads up to 200 kg. See specific instructions for installing the accessory.
Operate the switch (10) forward to raise the load, or backward to lower the load. The command is ON-
OFF, therefore it is not possible to modulate the manoeuvre speed, which occurs at a fixed speed set in
the factory.
The winch command cannot be performed at the same time as other commands.
To Next Page
Loading...
Need help?
General