Operating manual ALPHASEAPILOT MFC Issue 1.1 Page 21 of 84
ALPHASEAPILOT MFC
DODGE MODE: -
(i) Check that the Autopilot “REMOTE” key is activated.
(ii) Select DODGE on the NT920NFU selector switch.
(Confirmed by illumination of DODGE READY LED).
(iii) Move and hold the NT920NFU Jog Lever right (STBD) or Left (PORT) to apply
corresponding rudder and override the Autopilot.
(iv) Release the Jog Lever to centre when ready for the Autopilot to return the vessel
to the original Autopilot heading.
NFU MODE: -
(i) Check that the Autopilot “REMOTE” key is activated.
(ii) Select NFU on the NT920NFU selector switch.
(Confirmed by illumination of the POWER STEER LED).
(iii) Move the NT920NFU Jog Lever Right (STBD) or Left (PORT) and release the Jog
lever to centre when the required angle of applied rudder is attained.
(iv) Repeat Jog Lever operation as necessary to align the vessel on the new heading
required.
(v) Select DODGE or OFF on the NT920 NFU selector switch to return heading
control to the Autopilot which will maintain the vessel on the new (current)
heading.
To Next Page
Loading...