Alphatron ALPHASEAPILOT MFC - VII) Dodge Angle Calibration; VIII) Custom Turn Calibration

Operating manual ALPHASEAPILOT MFC Issue 1.1 Page 36 of 84
ALPHASEAPILOT MFC
2.6 (VII) Dodge Angle Calibration
The Dodge facility allows the operator to instruct a temporary Autopilot course change by a
preprogrammed amount stored in the “LIMITS” Menu.
To set the DODGE value (5° to 90°):-
a) Use the “LIMITS” key to enter the Limits Menu.
b) Use the “LIMITS” key again to select “DODGE” box followed by flashing current
value (5° to 90°).
c) Use the rotary (+/-) illum. control to set “DODGE” value required.
2.6 (VIII) Custom Turn Calibration
The CUSTOM turn facility allows the operator to instruct a permanent Autopilot course
change by a pre-programmed amount stored in the “LIMITS” Menu from 5° to 180° in 5°
steps.
To set the CUSTOM value (5° to 180°):-
a) Use the “LIMITS” key to enter the Limits Menu.
b) Use the “LIMITS” key again to select “CUSTOM” box followed by flashing
current value (5° to 180°).
c) Use the rotary (+/-) illum. control to set “CUSTOM” value required.