Alphatron ALPHASEAPILOT MFC - Section 2: Operator Controls and Sea Trials

Operating manual ALPHASEAPILOT MFC Issue 1.1 Page 23 of 84
ALPHASEAPILOT MFC
Section 2: Operator Controls and Sea Trials
Operator Controls and Displays Defined: -
2.1 The Autopilot STANDBY / OFF Key & Modes
2.2 The Autopilot ON Key Modes (Rudder / Thruster)
2.3 The Adaptive & Non Adaptive (PID) Autopilot Modes
2.4 The CONTROLS Menu
(i) Adaptive / Non Adaptive Selection
(ii) Rudder Control
(iii) Yaw Control
(iv) Counter Control
(v) Autothrust
(vi) Turn Type (ROT or RAD)
2.5 The Rotary (+/-) Illumination Control
2.6 The LIMITS Menu
(i) Rudder Limit
(ii) Off Heading Alarm
(iii) Course Comparator Alarm
(iv) Watch Alarm
(v) Rate of Turn (ROT) Calibration & Display (°/sec or °/min)
(vi) Radius of Turn (RAD) Calibration
(vii) Dodge Angle Calibration
(viii) Custom Turn Calibration
2.7 The AUTOTRIM Key (Automatic Permanent Helm)
2.8 The Alarm TEST / OFF Key
2.9 The TRACK Key
2.10 The REMOTE Key
2.11 The TURN MODE Keys
(i) Dodge
(ii) Custom
(iii)
+/-1 / +/-5