Altec LASSIE2 Plus - Page 130

130
Cut Position Adjustment
The paper feed pitch is adjusted as described below depending on the [Media detection settings].
Media detec-
tion settings
Description
Die-cut label
(Gap)
Transparent die-
cut label
 Specifying a positive value moves the cut position closer to the reference position
(print start position).
 Specifying a negative value moves the cut position away from the reference
position (print start position).
Die-cut label
(Blackmark)
 Specifying a positive value moves the cut position closer to the reference position
(print start position).
 Specifying a negative value moves the cut position away from the reference
position (print start position).
Backing paper
Label
Label
Print result
Print reference
(Print start position)
Cut position
Backing paper
Label
Label
Print result
Print reference
(Print start position)
Cut position