139
Chapter 3 Handling
3
Trouble Description Recovery method
Image/
Illustra-
tion
An error has occurred
The LCD displays the
content of the error.
See
"Error Recovery Method" on
page 151.
-
The print result is faded
or has lines (black/
white)
(Lines printed while
feeding by 25.4 mm/1
inch could be
improved; however, you
cannot remove them
completely.)
There are missing dots.
Perform nozzle check and check
whether print nozzles are clogged.
If the print nozzles are clogged, per-
form head cleaning. Hold down the
cleaning button for more than three
seconds to start head cleaning.
When [Printing operation mode] is set
to other than [Anti-missing Dot
mode], missing dots are permitted.
When no missing dots can be permit-
ted, change [Printing operation
mode] to [Anti-missing Dot mode].
See
"Nozzle Check Mode Settings" on
page 117.
No. 1
The shutters on the
platen on the outer side
of the paper are set to
open.
When the shutters on the platen on
the outer side of the paper are set to
open, air current may cause printing
trouble, and white lines may be
printed.
Follow the instructions on the label on
the top of the printer, and set the
shutters on the platen.
See
"Shutter Adjustment" on page 40.
No. 2
The paper you are using
differs from the paper
set in the [Media Type].
Check the paper you are using and
the [Media Type] settings.
For more information, see step 9 in
"Replacing Roll Paper with Fanfold
Paper" on page 66, or step 10 in
"Replacing Fanfold Paper with Roll
Paper" on page 75.
-
To Next Page
Loading...