145
Chapter 3 Handling
3
Auto Fit Page is not
available
The Auto Fit Page func-
tion is available for TM-
C3400, but it is not avail-
able for TM-C3500.
For thermal label printers, the label
size is generally considered as “print-
able area”, however for TM-C3400, it
is considered as “label size” - “mar-
gins” = printable area.
Therefore, TM-C3400 comes with the
Auto Fit Page function so that the
same paper layout can be used
even when the printable area is
smaller.
To be more precise, when [Auto Fit
Page] is enabled, the size including
the margins is reduced to fit the print-
able area.
For TM-C3500, enable [Borderless
Printing] to match the “label size”
and “printable area”.
Enable [Borderless Printing] if you
want to use the same paper layout
as for the thermal label printer.
-
The print position is mis-
aligned
The paper you are using
differs from the paper
set in the [Media Lay-
out].
If the paper you are using differs from
the paper set in the [Media Layout],
the image may not be printed at the
correct position.
Set Media Layout correctly.
For more information, see step 9 in
"Replacing Roll Paper with Fanfold
Paper" on page 66, or step 10 in
"Replacing Fanfold Paper with Roll
Paper" on page 75.
-
The label size and print-
able area do not
match
It is product specifica-
tions
On the [General] tab, if you select
[User Defined...] in Media Layout but
do not select [Borderless Printing],
the area minus the 1.5 mm margins
around the label becomes the print-
able area.
Enable [Borderless Printing] if you
want to use the whole label size as
the printable area.
When [Borderless Printing] is enabled,
images may be printed on the back-
ing paper; therefore, remove the 1.5
mm margin on all edges from the
print data.
-
Trouble Description Recovery method
Image/
Illustra-
tion
To Next Page
Loading...