144
Paper is smudged
The paper width and
the settings for the shut-
ters on the platen do
not match.
When the paper width and the set-
tings for the shutters on the platen do
not match, paper may be lifted; the
print head may touch and smudge
the paper.
Follow the instructions on the label on
the top of the printer, and set the
shutters on the platen.
See "Shutter Adjustment" on page 40
.
-
The paper you are using
differs from the paper
set in the [Media Type].
Check the paper you are using and
the [Media Type] settings.
For more information, see step 9 in
"Replacing Roll Paper with Fanfold
Paper" on page 66, or step 10 in
"Replacing Fanfold Paper with Roll
Paper" on page 75.
-
If the print head has for-
eign objects attached,
the paper may be
smudged.
Perform manual head cleaning.
Hold down the cleaning button for
more than three seconds to start
head cleaning.
-
The print head may
touch the paper and
the paper may
become smudged
because the platen’s
suction may be insuffi-
cient for some paper
you are using.
Set [Platen Vacuum Manual Adjust-
ment].
On the printer driver’s [Options] tab,
set [Platen Vacuum Manual Adjust-
ment].
You can also use the BSF file to set
[Platen Vacuum Manual Adjust-
ment]. See
"Exporting/Importing
Printer Driver Settings" on page 87.
-
Trouble Description Recovery method
Image/
Illustra-
tion
To Next Page
Loading...