147
Chapter 3 Handling
3
When paper is loaded,
it is fed and an error
occurs
For Full-page label,
Continuous paper, and
Transparent full-page
label
The paper you are using
does not match the
[Media detection set-
tings].
Check the paper you are using and
the printer’s [Media detection set-
tings].
See
"Media detection settings" on
page 114.
-
An error has occurred in
the sensor.
If the printer has been working prop-
erly so far, the sensor may be mal-
functioning. Contact your dealer for
repairs.
-
Label gap detection is
not available for fan-
fold paper
For fanfold paper, backing paper
thicker than that of roll paper is used
to avoid paper jam. Therefore, the
gap may not be detected even
when you are using genuine Epson
paper. If this happens, click [Printer
Setting Utility] on the [Printer Utilities]
tab in the printer driver to display the
Printer Setting Utility window. Select
[Printer Adjustment] - [Sensor Adjust-
ment] - [Adjust the Label Gap Detec-
tion Sensor]. For details, see
"Sensor
Adjustment" on page 135. If the gaps
are still not detected even after
adjusting the sensor, change the
detection method to using black
marks.
-
Trouble Description Recovery method
Image/
Illustra-
tion
To Next Page
Loading...