148
When paper is loaded,
it is fed and an error
occurs
For Die-cut label (Gap)
and Transparent die-cut
label
The paper you are using
does not match the
[Media detection set-
tings].
Check the paper you are using and
the printer’s [Media detection set-
tings].
See "Media detection settings" on
page 114
.
-
The transmittance of
the paper you are using
is out of the specifica-
tions.
The label gap may not be detected.
Infrared light is used to detect the
label gap; therefore, the infrared
transmittance of the backing paper
must be higher than the specified
value and that of the label part must
be lower than the specified value.
Check the paper specifications, and
use the paper that matches the
printer specifications.
You may be able to detect the gap
by performing [Adjust the Label Gap
Detection Sensor].
On the printer driver’s [Printer Utilities]
tab, click [Printer Setting Utility].
When the PrinterSetting screen is dis-
played, click [Printer Adjustment] -
[Sensor Adjustment] and perform
[Adjust the Label Gap Detection
Sensor].
See
"Sensor Adjustment" on page
135.
-
An error has occurred in
the sensor.
If the printer has been working prop-
erly so far, the sensor may be mal-
functioning. Contact your dealer for
repairs.
-
Trouble Description Recovery method
Image/
Illustra-
tion
To Next Page
Loading...