Altec LASSIE2 Plus - Page 220

220
Die-cut label (Blackmark) / Roll paper
When "Borderless Printing" is disabled
Top, bottom, left, right margins: 1.5 mm (Typical value)
Paper width
0.5 to 1.0 mm
12.0 mm or more*1
1.5 mm
Auto-cut position
Paper feeding direction
Print area
2.0 mm
Label area
1.5 mm
Center of paper width
Edge cutoff 2.0 mm
1.5 mm
Auto-cut position
Backing paper
Print area width
2.0 mm
Edge cutoff 2.0 mm
Black mark
position
Auto-cut position
Perforated line
1.5 mm
15.0 mm or more*2
18.0 mm or more*3
1.5 mm
*1 When auto cut is not performed: 
5.0 mm or more
*2 When auto cut is not performed:
8.0 mm or more
*3 When auto cut is not performed:
11.0 mm or more