IS-300A
4. How to Operate Screens
4-15
When WELD2 STOP/WELD COUNT is WELD2 STOP and COUNTER is
WORK
WELD COUNTER and WORK COUNTER are displayed. When the count
reaches the set WELD count value, WORK count value is incremented by
one.
This is different from WELD COUNTER described in in meaning.
When WELD2 STOP/WELD COUNT is WELD COUNT
WELD COUNTER is displayed. (See (10)(a).)
This is different from WELD COUNTER described in in meaning.
(Note) Monitored value
Only the last monitored value and the number of counts of each
SCHEDULE are kept for a period of about 10 days after the power is
turned off.
When the repetition welding is performed with PULSATION or OFF time
setting, only the last data is displayed as the monitored value. The passing
data is not displayed.
The monitor display is not automatically updated depending on the
MONITOR DISP MODE setting. (See (9)(n).)
To Next Page
Loading...
