AMF S-311 - Pressure Adjutment on the Regulators of the Filter Unit

S-311+ ACL
1-24 ACL
Released: 01/2014
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
3. PRESSURE ADJUTMENT ON THE REGULATORS OF THE FILTER UNIT
Correct pressure adjustment affect the cutting knifes life cycle.
1. Adjust pressure 0,6 MPa (0,5) MPa on the main regulator .
2. Adujst pressure 0,4 MPa on cutting regulator .
3. Adjust pressure 0,2-0,25 MPa on auxiliary regulator .
Warning!
The knives can be damaged in the case the parameters set by manufacturer on B and C regulators are not observed.