Released:01/2014
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
12. CYCLE MODE
It is possible to set the type and the number of buttonholes which will be sewn in one sewing cycle.
CAUTION:
ModicationAF - it is necessary to use the same cutting length for all buttonholes in one cycle. Imitation (no cut)
buttonholes of different length can be included in the sewing cycle.
ModicationCT - to prevent the machine from damage, the length of buttonholes in one cycle must be the same as
the length of a cutting steel in the machine. To trim the lower threads, set the length of a buttonhole according to the
installed clamp feet - see section D3.
Number of buttonholes
in CYCLE MODE
Button for CYCLE MODE choice
(range 0 - 47 cycles)
Saving button
CYCLE MODE
Return
To main display
To Next Page
Loading...
