AMF S-311 - B - Machine Assembly; Content of the Shipping Box; Table Adjustment

S-311
1-10
Released:01/2014
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
B - MACHINE ASSEMBLY
1. CONTENT OF THE SHIPPING BOX
1.1. If it is not mentioned otherwise during ordering, the shipping container
usually contains:
— assembled machine on the stand with electroinstalation
     —boxwiththeaccessories(specicationinthespareparts
section)
— dis-assembled thread stand
1
— operation manual with the spare parts manual
1.2. When unpacking the container, follow labels which are on a cover.
CAUTION: If the container was damaged during the transport, inform the carrier. Check the contents of the container
withorder.Intheeventofanerror,immediatelyinformthemanufacturer-latenoticationofanerrorinshipmentmay
result in loss of claim.
2. TABLE ADJUSTMENT
2.1. After you will unpack the machine, move the machine to its appointed place. The machine is supplied with the
stand with standart height for working in seat. For another stand implementation is necessary to make an agreement
with the customer. The recommended height of the stand (table) is 870 mm. Tighten the screws
2
very well.
2.2. Tostabilizethetable,usetheoorpads
3
, which are controlled by hand screw
4
. Check the levelness of the
adjusted table.
2.3 Eliminate the shipping band
5
, which holds the head in place. If transporting machine to a different location, it
is necessary to fasten the table to prevent shifting in transit.