AMF S-311 - S-311+Acl

1-5 ACL
1-5 ACL
1-6 ACL
1-7 ACL
1-9 ACL
1-9 ACL
1-10 ACL
1-10 ACL
1-11 ACL
1-12 ACL
1-12 ACL
1-13 ACL
1-13 ACL
1-14 ACL
1-15 ACL
1-16 ACL
1-17 ACL
1-17 ACL
1-19 ACL
1-20 ACL
1-20 ACL
1-21 ACL
1-22 ACL
1-22 ACL
1-23 ACL
1-24 ACL
S-311+ACL
Released: 01/2014
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
TABLE OF CONTENTS
A - INTRODUCTION..................................................................................................................
1. GENERAL INFORMATION....................................................................................................
2. TERMINOLOGY OF MACHINE PARTS................................................................................
3. TECHNICAL SPECIFICATIONS ...........................................................................................
B - CORRECT USAGE..............................................................................................................
1. SETTING UP THE MACHINE INTO HOME POSITION TO GET READY FOR SEWING.....
C - MACHINE INSTALLATION...................................................................................................
1. OPTICAL SENSOR INSTALATION........................................................................................
2. KIT ACL-LPE INSTALLATION................................................................................................
2.1 FEED CABLE INSTALLATION FOR SWITCH VALVE OF CUTTING...................................
2.2 LPE CUTTING BLOCK INSTALLATION..............................................................................
D - OPERATING THE MACHINE FUNCTIONS..........................................................................
1. SEWING A BUTTONHOLLE..................................................................................................
2. DESCRIPTION OF THE ACL SCREEN.................................................................................
3. SETTING UP ACL DISPLAY..................................................................................................
4. LAPEL SYSTEM - OPTIONAL ACCESSORY TO ACL MECHANISM...................................
4.1 SETTING UP THE MACHINE FOR ACL LP1 (ACL-LP2, ACL-LPE) VERSION................
4.2 SETTING UP THE LAPEL BUTTONHOLE FOR ACL-LP1 (ACL-LP2, ACL-LPE) VERSION.....
4.2 SETTING UP THE LAPEL BUTTONHOLE FOR ACL-LP1 (ACL-LP2, ACL-LPE) VERSION.....
4.3 USING THE PROGRAMMED BUTTONHOLE IN CYCLE MODE.......................................
5. OPTICAL SENSOR - OPTIONAL ACCESSORY FOR LAPEL SYSTEM ..............................
5.1 OPTICAL SENSOR - DEVICE ACTIVATION.......................................................................
5.2 USING THE PROGRAMMED BUTTONHOLE IN CYCLE MODE WITH OPTICAL SENSOR
ACTIVATED...........................................................................................................................
E - STANDARD ADJUSTMENT.................................................................................................
1. SLIDING BLOCK HOLDER ADJUSTMENT...........................................................................
2. CUTTING BLOCK POSITION ADJUSTMENT IN ACL MECHANISM...................................
3. PRESSURE ADJUTMENT ON THE REGULATORS OF THE FILTER UNIT........................